OSHA 29 CFR 1910 Sbpt S- Electrical
This course provides an overview of basic electrical safety for individuals with little or limited training or familiarity with electrical hazards and is designed for any worker who may use extension cords, electric tools, etc. This course covers the topics included in OSHA 29 CFR 1910.301-399 Subpart S.
Establish the conditions covered by OSHA’s 1910 Subpart S Design Safety Standards
Outline the general requirements for electrical safety standards
Understand the proper use and identification of circuits and conductors
Define the standards for electrical grounding and protection
Establish the general requirements for wiring methods and equipment
Establish the guidelines and requirements for special purpose equipment
Lesson 1 Introduction to Electrical Safety
Lesson 2 Wiring Design and Protection
Lesson 3 Wiring Methods, Components, and Equipment
Lesson 4 Specific Purpose Equipment
Please see the state/regulatory requirement from the course catalog page.
This course has been approved for 1 hour.
Quizzes - All quizzes must be passed with a 100% to proceed forward to the next lesson.
Final Exam- Final Exam must be passed with a 70% to pass the course. The final exam can be taken three times if necessary.
Length: 1 hours
500MHz Pentium or faster with 512MB Ram (1GB recommended)
1024 x 768 minimum monitor screen resolution with 16-bit video card
Windows 2000, XP or later
Broadband connection (256 kbps or greater) connection recommended
Internet Explorer 6.0+ or Firefox 2.0+
Flash Player 9.0+ required for most courses
Sound card with speakers or headphones for audio playback